Metal roofs, shingle roofs and honest repairs for Galvin, WA homeowners. Family owned since 2002, and estimates are always free.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Galvin.
One leak usually has company. We fix the one you called about and check over the rest of the roof while we are already up there.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
If wind got under your roof once it will try again. We fix the damage and close the edge back up so there is nothing left to catch.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Waterproofing details on additions, porches and low slope tie ins, where two roofs meet and most leaks quietly begin.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Where it makes sense we set low slope metal over a problem section so it finally drains instead of ponding after every rain.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Galvin homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Galvin home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Galvin homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
If your roof needs a repair and not a replacement, we say so. Plenty of our best customers are people we talked out of a job they did not need yet.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
The questions that come up on just about every estimate we write.
A typical Galvin shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Sometimes. If the decking is sound and there is only one layer of shingles, a Galvin metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Often, yes. Plenty of the Galvin roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Yes. Gutters, guards, soffit and fascia are all part of keeping the edge of a Galvin roof dry, so we handle them along with the roof instead of sending you off to find somebody else to finish the job.
Most Galvin metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
A metal roof installed properly on a Galvin home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
Honest words from customers who trusted Roofing Brothers with their roof.
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
Our crews cover the surrounding area, not only the city limits.